General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
Table 3-6 show cdp Output Details
Output
CDP Version
Global CDP State Whether Enterasys Discovery Protocol is globally
Global Hold Time Transmit frequency (in seconds) of Enterasys Discovery
Port
State
3.2.6.2
set cdp
Use this command to enable or disable the Enterasys Discovery Protocol on one or more ports.
set cdp {auto | disable | enable} [port-string]
3-70
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
What It Displays...
Current Enterasys Discovery Protocol version number.
auto-enabled, enabled or disabled.
Protocol messages. For details on using the set cdp interval
command to change the default value of 60, refer to
Section
3.2.6.2.
Port designation. For a detailed description of possible
port-string values, refer to
Whether Enterasys Discovery Protocol is enabled, disabled
or in auto mode on this port. For details on using the set cdp
command to change the default setting of auto, refer to
Section
3.2.6.2.
Section
4.1.2.