SNMP Command Set
Configuring SNMP Notification Parameters
5.2.7.13 set snmp notifyprofile
Use this command to create an SNMP notify filter profile configuration. This associates a
notification filter, created with the set snmp notifyfilter command
SNMP target parameters to determine which management targets should not receive SNMP
notifications.
set snmp notifyprofile profile targetparam targetparam [volatile | nonvolatile]
Syntax Description
profile
targetparam
targetparam
volatile |
nonvolatile
Command Defaults
If storage type is not specified, nonvolatile will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create an SNMP notify profile named area51 and associate a target
parameters entry.
Matrix>set snmp notifyprofile area51 targetparam v3ExampleParams
5.2.7.14 clear snmp notifyprofile
Use this command to delete an SNMP notify profile configuration.
clear snmp notifyprofile profile targetparam targetparam
5-60
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies an SNMP filter notify name.
Specifies an associated entry in the SNMP Target Params
Table.
(Optional) Specifies a storage type.
(Section
5.2.7.10), to a set of