Table of Contents
Advertisement
Example
This example shows how to set the RIP receive version to 2 for update packets received on VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip rip receive version 2
About RIP Authentication
The following tasks must be completed to configure RIP authentication on the Matrix E1 device:
1. Create a key chain as described in
2. Add a key to the chain as described in
3. Specify an authentication string for the key as described in
4. Set the time periods the authentication string can be received and sent as valid as described in
Section 13.1.1.12
5. Enable a key chain for use on an interface as described in
6. Specify an authentication mode as described in
13.1.1.9 key chain
Creates or deletes a key chain used globally for RIP authentication.
key chain name
Syntax Description
name
Command Syntax of the "no" Form
The "no" form of this command deletes the specified key chain:
no key chain name
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router(config)#
Section
and
Section
13.1.1.13.
Specifies a name for the key chain.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Process Overview: Routing Protocol Configuration
13.1.1.9.
Section
13.1.1.10.
Section
Section
13.1.1.15.
Section
13.1.1.11.
13.1.1.14.
Configuring RIP
13-11
Advertisement
Table of Contents
