Port Configuration Command Set
Configuring Link Aggregation
4.3.13.4 show port lacp
Use this command to display link aggregation information for one or more underlying physical
ports.
show port lacp {[port-string] [counters port-string] [detail port-string]}
Syntax Description
port-string
counters port-string Displays LACP counter information for one or more
detail port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display LACP status information
case, ports ge.0.1 and ge.0.2 have been statically assigned to an aggregator (lag.0.1), but not
attached, as indicated by the asterisks placed in the aggregator names:
Matrix>show port lacp ge.0.*
Port
Key
--------------------------------------------------------------------------
ge.0.1
100
ge.0.2
100
ge.0.3
100
ge.0.4
100
ge.0.5
100
ge.0.6
100
4-66
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Displays LACP information for specific port(s). For a
detailed description of possible port-string values, refer
to
ports.
Displays detailed LACP status information for one or
more ports.
State
Agg
-F---AlA
l*g.0.1
-F---AlA
l*g.0.1
-F--SAlA
-------
-F--SAlA
-------
-F--SAlA
-------
-FDCSAlA
-------
Section
4.1.2.
f
POSysID
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
00:00:00:00:00:00
or all Gigabit Ethernet ports. In this
POKey
1
1
3
4
5
6
LACPRxTx
Disabled
Disabled
Enabled
Enabled
Enabled
Enabled