Table of Contents
Advertisement
5.2.5
Configuring SNMP Target Parameters
Purpose
To review and configure SNMP target parameters. This controls where and under what
circumstances SNMP notifications will be sent. A target parameter entry can be bound to a target
IP address allowed to receive SNMP notification messages with the set snmp targetaddr
command
(Section
5.2.6.2).
Commands
The commands needed to review and configure SNMP target parameters are listed below and
described in the associated section as shown.
•
show snmp targetparams
•
set snmp targetparams
•
clear snmp targetparams
5.2.5.1
show snmp targetparams
Use this command to display SNMP parameters used to generate a message to a target.
show snmp targetparams [targetparams]
Syntax Description
targetparams
Command Defaults
If targetParams is not specified, entries associated with all target parameters will
be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
(Section
5.2.5.1)
(Section
5.2.5.2)
(Section
5.2.5.3)
(Optional) Displays entries for a specific target
parameter.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
SNMP Command Set
Configuring SNMP Target Parameters
5-37
Advertisement
Table of Contents
