Table of Contents
Advertisement
Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
Syntax Description
cisco | h323 |
siemens
profile-id
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to assign policy profile 1 to all H.323 phones detected
Matrix>set cep policy h323 1
11.2.6.5 set cep detection
Use this command to create a new H.323 or Siemens phone detection configuration group, or
enable, disable or remove an existing group.
set cep detection detection-id {create | delete | disable | enable}
NOTE: This command applies only to Siemens and H.323 phone detection. Cisco
detection uses CiscoDP as its discovery method.
11-78
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies the default policy as Cisco, H.323 or Siemens
phone detection.
Specifies an ID for this CEP policy profile. This must be
configured using the policy management commands
described in
Chapter
11. Valid values are 1 - 65535.
:
Advertisement
Table of Contents
