Table of Contents
Advertisement
SNMP Command Set
Configuring SNMP Users, Groups and Communities
Table 5-4 show snmp user Output Details
Output
EngineId
Username
Auth protocol
Privacy protocol
Storage Type
Row status
5.2.2.2
set snmp user
Use this command to create a new SNMPv3 user.
set snmp user user [authentication md5 [privacy]] [remote remoteid] [volatile |
nonvolatile]
Syntax Description
user
authentication md5 (Optional) Specifies the authentication type required for
privacy
remote remoteid
volatile |
nonvolatile
Command Defaults
•
•
5-16
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies a name for the SNMPv3 user.
this user as MD5.
(Optional) Applies DES encryption.
(Optional) Registers the user on a specific remote SNMP
engine.
(Optional) Specifies a storage type for this user entry.
If authentication is not specified, no authentication will be applied.
If privacy is not specified, no encryption will be applied.
What It Displays...
SNMP local engine identifier.
SNMPv1 or v2 community name or SNMPv3 user
name.
Type of authentication protocol applied to this
user.
Whether a privacy protocol is applied when
authentication protocol is in use.
Whether access entries for this group are stored in
volatile, nonvolatile or read-only memory.
Status of this entry: active, notInService, or
notReady.
Advertisement
Table of Contents
