Table of Contents
Advertisement
9.3.3
Configuring Quality of Service (QoS)
Purpose
To configure one or more ports with the following Layer 2 switching features:
•
Four priority queues on each port.
•
Programmable scheduling per transmit (Tx) port according to fixed priority, weighted
round-robin (in percentage of traffic per queue), or hybrid algorithm.
Command Descriptions
The commands to configure the Quality of Service are listed below and described in the associated
section.
•
show port qos
(Section
•
set port qos sp
(Section
•
set port qos wrr
(Section
•
set port qos hybrid
9.3.3.1
show port qos
Use this command to display Quality of Service information, including the current QoS algorithm
and associated queue settings, for one or more ports.
show port qos [port-string]
Syntax Description
port-string
Command Defaults
If the port-string is not specified, the QoS settings for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
9.3.3.1)
9.3.3.2)
9.3.3.3)
(Section
9.3.3.4)
(Optional) Display QoS settings for specific port(s). For a
detailed description of possible port-string values, refer
to
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Port Priority and Classification Configuration Commands
Section
4.1.2.
Configuring Quality of Service (QoS)
9-11
Advertisement
Table of Contents
