Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
14.3.9.6 set flowlimit shutdown
Use this command to enable or disable the flow limit shut down function. When enabled, this allows
ports configured with a "disable" action to shut down. For information on using the set flowlimit
limit command to configure set a disable action on a port, refer to
set flowlimit shutdown {enable | disable}
Syntax Description
enable | disable
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to enable the flow limit shut down function:
Matrix>set flowlimit shutdown enable
14-110
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Enables or disables the flow limit shut down function.
Section
14.3.9.3.