Table of Contents
Advertisement
Syntax Description
detection-id
porthigh |
portlow port
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set port 65 as the minimum port to be used for convergence end points
detection for CEP group 1
Matrix>set cep detection portlow 65
11.2.6.10set cep initialize
Use this command to re-initialize convergence end points detection on one or more CEP-enabled
ports.
set cep initialize port-string
Configuring Convergence End Points (CEP) Phone Detection
Specifies a CEP discovery group ID. This group must be
created and enabled using the set cep detection command
as described in
2147483647.
Specifies a maximum or minimum UDP or TCP port to be
used for convergence end points detection.Valid values are
1 - 65535.
:
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Logging and Network Management Command Set
Section
11.2.6.5. Valid values are 1 -
11-83
Advertisement
Table of Contents
