Table of Contents
Advertisement
Process Overview: Routing Protocol Configuration
Configuring OSPF
13.1.2 Configuring OSPF
Purpose
To enable and configure the Open Shortest Path First (OSPF) routing protocol.
OSPF Configuration Task List and Commands
Table 13-2
lists the tasks and commands associated with OSPF configuration. Commands are
described in the associated section as shown.
.
NOTE: Enabling OSPF with the router ospf and network commands are required if
you want to run OSPF on the device. All other tasks are optional.
Table 13-2 OSPF Configuration Task List and Commands
To do this...
Enable OSPF configuration mode,
associate a network and assign a router
ID.
Configure OSPF Interface Parameters.
•
Set the cost of sending a packet on
an OSPF interface.
•
Set priority to help determine the
OSPF designated router for the
network.
•
Adjust timers and message
intervals.
13-26
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Use these commands...
router ospf
(Section
network
(Section
13.1.2.2)
router id
(Section
13.1.2.3)
ip ospf cost
(Section
ip ospf priority
(Section
timers spf
(Section
ip ospf retransmit-interval
ip ospf transmit-delay
ip ospf hello-interval
ip ospf dead-interval
13.1.2.1)
13.1.2.4)
13.1.2.5)
13.1.2.6)
(Section
13.1.2.7)
(Section
13.1.2.8)
(Section
13.1.2.9)
(Section
13.1.2.10)
Advertisement
Table of Contents
