Example
This example shows how to globally enable CEP detection
Matrix>set cep enable
11.2.6.3 set cep port
Use this command to enable or disable a CEP detection type on one or more ports.
set cep port port-string {cisco | h323 | siemens} {enable | disable}
Syntax Description
port-string
cisco | h323 |
siemens
enable | disable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Cisco phone detection on port fe. 3. 1
Matrix>set cep port fe.3.1 cisco enable
11.2.6.4 set cep policy
Use this command to set a global default policy for a CEP detection type. This is the policy that will
be applied when a phone of the specified type is detected on a port. It must be configured using the
policy management commands described in
set cep policy {cisco | h323 | siemens} profile-id
Configuring Convergence End Points (CEP) Phone Detection
Specifies the port(s) to enable or disable. For a detailed
description of possible port-string values, refer to
Section
4.1.2.
Specifies the CEP detection that will be applied as Cisco,
H.323 or Siemens phone detection.
Enables or disables CEP detection as specified.
Chapter
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Logging and Network Management Command Set
:
11.
:
11-77