Table of Contents
Advertisement
Command Mode
Read-Only.
Example
This example shows how to display SNMPv3 information about the "public" community name:
Matrix>show snmp community public
Community Name: public
Security User Name: initial-restricted
SNMP Engine ID: 80:00:38:18:03:00:01:f4:d2:bc:80
Storage Type: nonvolatile
Row Status: active
5.2.2.11 set snmp community
Use this command to create a relationship between an SNMP v1 or v2 community name and an
SNMPv3 access policy.
set snmp community {name user username} [volatile | nonvolatile]
Syntax Description
name
user username
volatile |
nonvolatile
Command Defaults
If storage type is not specified, nonvolatile will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Configuring SNMP Users, Groups and Communities
Specifies a community name.
Specifies the SNMPv3 user name to which this
community name will be mapped. For details on creating
an SNMP v3 user, refer to
(Optional) Specifies the storage type for these entries.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
SNMP Command Set
Section
5.2.2.2.
5-25
Advertisement
Table of Contents
