Table of Contents
Advertisement
Process Overview: Routing Protocol Configuration
Configuring RIP
13.1.1 Configuring RIP
Purpose
To enable and configure the Routing Information Protocol (RIP).
RIP Configuration Task List and Commands
Table 13-1
lists the tasks and commands associated with RIP configuration. Commands are
described in the associated section as shown.
NOTE: Enabling RIP with the router rip and network commands is required if you
want to run RIP on the device. All other tasks are optional.
Table 13-1 RIP Configuration Task List and Commands
To do this...
Enable RIP configuration mode and
associate a network.
Allow unicast updates by defining a
neighboring router.
Configure an administrative distance.
Apply offsets to RIP routing metrics.
Adjust timers.
Specify a RIP version.
13-2
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Use these commands...
router rip
(Section
13.1.1.1)
network (RIP)
(Section
neighbor (RIP)
(Section
distance
(Section
13.1.1.4)
ip rip offset
(Section
timers
(Section
13.1.1.6)
ip rip send version
(Section
ip rip receive version
13.1.1.2)
13.1.1.3)
13.1.1.5)
13.1.1.7)
(Section
13.1.1.8)
Advertisement
Table of Contents
