Table of Contents
Advertisement
Table 12-1 VLAN and Loopback Interface Configuration Modes
For Routing
Interface Type...
VLAN
Loopback
For details on how to enable all router CLI configuration modes, refer back to
For details on configuring routing protocols, refer to
NOTE: The command prompts used in examples throughout this guide show a system
where VLAN 1 has been configured for routing. The prompt changes depending on your
current configuration mode, and the interface types and numbers configured for routing
on your system.
Purpose
To enable routing interface configuration mode on the device, to create VLAN or loopback routing
interfaces, to review the usability status of interfaces configured for IP, to set IP addresses for
interfaces, and to enable interfaces for IP routing at device startup.
Commands
The commands needed to review and configure interface settings are listed below and described in
the associated section as shown:
•
show interface
•
interface
(Section
•
show ip interface
•
ip address
(Section
•
no shutdown
(Section
12.2.1.1 show interface
Use this command to display information about all interfaces (VLANs or loopbacks) configured on
the router.
show interface [vlan vlan-id | loopback loopback-id]
Enter (in Global
Configuration Mode)...
vlan vlan-id
loopback loopback-id
12.2.1.2)
(Section
12.2.1.3)
12.2.1.4)
12.2.1.5)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
IP Configuration Command Set
Configuring Routing Interface Settings
Resulting Prompt...
Matrix>Router(config-if(Vlan 1))#
Matrix>Router(config-if (Lpbk 1))#
Chapter
13.
Table
3-10.
12-3
Advertisement
Table of Contents
