Table of Contents
Advertisement
SNMP Command Set
Configuring SNMP Target Addresses
5.2.6
Configuring SNMP Target Addresses
Purpose
To review and configure SNMP target addresses which will receive SNMP notification messages.
An address configuration can be linked to optional SNMP transmit, or target, parameters (such as
timeout, retry count, and UDP port) set with the set snmp targetparams command
(Section
5.2.5.2).
Commands
The commands needed to review and configure SNMP target addresses are listed below and
described in the associated section as shown.
•
show snmp targetaddr
•
set snmp targetaddr
•
clear snmp targetaddr
5.2.6.1
show snmp targetaddr
Use this command to display SNMP target address information.
show snmp targetaddr [targetaddr]
Syntax Description
targetaddr
Command Defaults
If targetAddr is not specified, entries for all target address names will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
5-42
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
(Section
5.2.6.1)
(Section
5.2.6.2)
(Section
5.2.6.3)
(Optional) Displays information for a specific target
address name.
Advertisement
Table of Contents
