Table of Contents
Advertisement
Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
Example
This example shows how to show Spanning Tree status for all Gigabit Ethernet ports:
Matrix>show spantree portadmin ge.*.*
Port ge.0.1 has portadmin set to enabled.
Port ge.0.2 has portadmin set to enabled.
Port ge.0.3 has portadmin set to enabled.
Port ge.0.4 has portadmin set to enabled.
Port ge.0.5 has portadmin set to enabled.
Port ge.0.6 has portadmin set to enabled.
6.2.2.2
set spantree portadmin
Use this command to enable or disable the Spanning Tree algorithm on one or more ports.
set spantree portadmin port-string {enable | disable}
NOTE: Spanning Tree must be disabled on ports that will be dedicated as IP routing
uplinks (VLANs). To display administrative status for all Spanning Tree ports, use the
show spantree portadmin command as detailed in
configuring VLANs for IP routing, refer to
Syntax Description
port-string
enable | disable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable Spanning Tree on Fast Ethernet front panel port 12:
Matrix>set spantree portadmin fe.0.12 disable
6-38
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Section
Specifies the port(s) for which to enable or disable
Spanning Tree. For a detailed description of possible
port-string values, refer to
Enables or disables Spanning Tree.
Section
6.2.2.1. For details on
3.3.2.
Section
4.1.2.
Advertisement
Table of Contents
