Table of Contents
Advertisement
Port Configuration Command Set
Configuring Link Aggregation
Command Mode
Read-Write.
Example
This example shows how to disable LACP:
Matrix>set lacp disable
4.3.13.2 set lacp static
Use this command to assign one or more underlying physical ports to a Link Aggregation Group
(LAG). This provides the ability to hard code LAG trunks, similar to forming trunks while the
device is in port trunking mode.
NOTES:
Group to form and attach to the specified LAG port.
Usage considerations discussed in
Ports and aggregators that are not statically assigned can still form trunks dynamically.
A port that is not statically assigned can never join an aggregator that has ports
statically assigned to it.
Static LAG configuration should be performed by personnel who are knowledgeable
about Link Aggregation. Misconfiguration can result in LAGs not being formed, or in
ports attaching to the wrong LAG port, affecting proper network operation.
set lacp static lagportstring port-string
Syntax Description
lagportstring
port-string
Command Defaults
None.
Command Type
Switch command.
4-64
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
At least two ports need to be assigned to a LAG port for a Link Aggregation
Specifies the LAG aggregator port to which new ports
will be assigned.
Specifies the member port(s) to add to the LAG. For a
detailed description of possible port-string values, refer
to
Section 4.3.10.1
Section
4.1.2.
apply to statically created LAGs.
Advertisement
Table of Contents
