Table of Contents
Advertisement
Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
Command Mode
Read-Only.
Example
This example shows how to display the span guard timeout setting:
Matrix>show spantree spanguardtimeout
spanguard timeout is set at 300 seconds.
6.2.2.18 set spantree spanguardtimeout
Use this command to set the amount of time (in seconds) an edge port will remain locked by the
span guard function.
set spantree spanguardtimeout timeout
Syntax Description
timeout
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the span guard timeout to 600 seconds:
Matrix>set spantree spanguardtimeout 600
6.2.2.19 clear spantree spanguardtimeout
Use this command to reset the Spanning Tree span guard timeout to the default value of 300
seconds.
clear spantree spanguardtimeout
6-50
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies a timeout value in seconds. Valid values are 0
(forever) to 65535.
Advertisement
Table of Contents
