Table of Contents
Advertisement
Syntax Description
interval
port-string
Command Defaults
If port-string is not specified, hello time will be set for all ports (if bridge hello
mode is disabled), or for the bridge (if bridge hello mode is enabled). For
information on using the set spantree bridgehellomode command, refer to
Section
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the bridge hello time to 3 seconds:
Matrix>set spantree hello 3
6.2.1.22 clear spantree hello
Use this command to reset the bridge hello time for the bridge or for one or more ports to the
default value of 2 seconds.
clear spantree hello [port-string]
Specifies the number of seconds the system waits before
broadcasting a bridge hello message (a multicast message
indicating that the system is active). Valid values are 1 - 10.
(Optional) Sets the hello time for specific port(s).
6.2.1.19.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
NOTE: Port-string cannot be specified if bridge
hello mode is enabled. For information on using the
set spantree bridgehellomode command, refer to
Section
6.2.1.19.
6-23
Advertisement
Table of Contents
