Table of Contents
Advertisement
Example
This example shows how to display broadcast information for Fast Ethernet front panel port 1,
where broadcast suppression is enabled and set to 500 packets per second (pps):
Matrix>show port broadcast fe.0.1
Broadcast Suppression enabled for port fe.0.1 at 500 pps
4.3.14.2 set port broadcast
Use this command to set the broadcast suppression limit in packets per second on one or more ports.
This sets a threshold on the broadcast traffic that is received and switched out to other ports.
set port broadcast port-string packet_count [disable | enable]
Syntax Description
port-string
packet_count
disable | enable
Command Defaults
If enable or disable is not specified, port broadcast packet_count will be set on
specified ports where broadcast suppression is enabled.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to enable broadcast suppression to 800 packets per second on Fast
Ethernet front panel ports 10 through 13:
Matrix>set port broadcast fe.0.10-13 800 enable
Specifies the port(s) for which to enable or disable
broadcast suppression. For a detailed description of
possible port-string values, refer to
Specifies the packets per second threshold on broadcast
traffic. Maximum value is 1488100 for Gigabit and
148810 for Fast Ethernet.
(Optional) Disables or enables broadcast suppression.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Port Configuration Command Set
Configuring Port Broadcast Suppression
Section
4.1.2.
4-71
Advertisement
Table of Contents
