Preparing the Device for Router Mode
Enabling Router Configuration Modes
3.3.3
Enabling Router Configuration Modes
The Matrix E1 CLI provides different modes of router operation for issuing a subset of commands
from each mode.
Table 3-10
NOTE: The command prompts used in examples throughout this guide show a system
where VLAN 1 has been configured for routing. The prompt changes depending on your
current configuration mode, and the interface types and numbers configured for routing
on your system.
Table 3-10 Router CLI Configuration Modes
Use this mode...
Privileged EXEC
Mode
Global
Configuration
Mode
Interface
Configuration
Mode
Router
Configuration
Mode
3-96
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
describes these modes of operation.
To...
•
Set system
operating
parameters
•
Show
configuration
parameters
•
Save/copy
configurations
Set system-wide
parameters.
Configure router
interfaces.
Set IP protocol
parameters.
Access method...
Type router
from switch mode.
Type
configure
from
terminal
Privileged EXEC
mode.
Type interface
and the interface's
vlan_id from
Global
Configuration
mode.
Type router
and the protocol
name from Global
or Interface
Configuration
mode.
Prompt...
Matrix>Router#
Matrix>Router(config)#
Matrix>Router
(config-if(Vlan
<vlan_id>))#
Matrix>Router
(config-router)#