Table of Contents
Advertisement
14.3.9.7 set flowlimit notification
Use this command to enable or disable flow limit notification, or to set a notification interval. When
enabled, this allows ports configured with a "trap" action to send an SNMP trap message when a
specified flow limit is reached. For information on using the set flowlimit limit command to
configure a trap action on a port, refer to
set flowlimit notification {enable | disable | interval interval}
Syntax Description
enable | disable
interval interval
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to enable the flow limit notification function:
Matrix>set flowlimit notification enable
14.3.9.8 set flowlimit clearstats
Use this command to reset flow limiting statistics back to default values on one or more port(s).
set flowlimit port-string clearstats
Syntax Description
port-string
Command Type
Switch command.
Section
14.3.9.3.
Enables or disables SNMP notification.
Specifies a notification interval (in seconds) for SNMP trap
messages. Valid values are 0 - 4294967295.
Specifies port(s) on which flow limiting statistics will be
cleared.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
14-111
Advertisement
Table of Contents
