Table of Contents
Advertisement
3.2.6.1
show cdp
Use this command to display the status of the Enterasys (CDP) Discovery Protocol and message
interval on one or more ports.
show cdp [port-string]
Syntax Description
port-string
Command Defaults
If port-string is not specified, the CDP state for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display Enterasys Discovery Protocol for Fast Ethernet front panel
ports 3 through 11:
Matrix>show cdp fe.0.3-11
CDP Version :
Global CDP State :
Global Hold Time :
Port
---------------------------------------------------------------
Table 3-6
(Optional) Displays Enterasys Discovery Protocol
information for specific port(s). For a detailed description
of possible port-string values, refer to
6
State
fe.0.3
auto
fe.0.6
auto
fe.0.9
auto
provides an explanation of the command output.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Configuring Enterasys and Cisco Discovery Protocols
auto
180
Port
State
fe.0.4
auto
fe.0.7
auto
fe.0.10
auto
General Configuration Command Set
Section
4.1.2.
Port
State
fe.0.5
auto
fe.0.8
auto
fe.0.11
auto
3-69
Advertisement
Table of Contents
