Table of Contents
Advertisement
Syntax Description
time
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the Cisco Discovery Protocol timer to 120 seconds:
Matrix>set ciscodp timer 120
3.2.6.7
set ciscodp holdtime
Use this command to set the time to live (TTL) for Cisco Discovery Protocol PDUs. This is the
amount of time (in seconds) neighboring devices will hold PDU transmissions from the sending
device.
set ciscodp holdtime time
Syntax Description
time
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Configuring Enterasys and Cisco Discovery Protocols
Specifies the number of seconds between PDU
transmissions. Valid values are 5 - 254.
Specifies the time to live for PDUs. Valid values are 10 -
255.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
General Configuration Command Set
3-75
Advertisement
Table of Contents
