Set Newaddrtrap - Enterasys 1G58x-09 Configuration Manual

Example
This example shows how to display the status of the new MAC address trap function on all Gigabit
Ethernet ports:
Matrix>show newaddrtrap ge.*.*
5.2.7.5

set newaddrtrap

Use this command to enable or disable SNMP trap messaging, globally or on one or more ports,
when new source MAC addresses are detected.
NOTE: Transmitting SNMP new address traps requires that you configure the device
with the SNMP management station information using the set trap command as
described in
set newaddrtrap [port-string] {enable | disable}
Syntax Description
port-string
enable | disable
Command Defaults
None.
Command Type
Switch command.
New Address Trap Globally disabled
Port Enable State
------- -----------
ge.0.1 disabled
ge.0.2 disabled
ge.0.3 disabled
ge.0.4 disabled
ge.0.5 disabled
ge.0.6 disabled
Section 5.2.7.2.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
(Optional) Enables or disables the MAC address trap
function on specific port(s). If new source MAC
addresses are detected via these ports, an SNMP trap
message will be sent to the management station.
Globally enables or disables the MAC address trap
function on all device ports.
SNMP Command Set
Configuring SNMP Notification Parameters
5-51