4.3.2.2
set port enable
Use this command to administratively enable one or more ports.
set port enable port-string
Syntax Description
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Fast Ethernet front panel port 3:
Matrix>set port enable fe.0.3
4.3.3
Setting Speed and Duplex Mode
Purpose
To set the current operational speed in Mbps and to set the default duplex mode: Half, for half
duplex, or Full, for full duplex.
NOTE: These settings only take effect on ports that have auto-negotiation disabled.
Commands
The commands needed to set port speed and duplex mode are listed below and described in the
associated section as shown.
•
show port speed
(Section
4.3.3.1)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies the port(s) to enable. For a detailed description
of possible port-string values, refer to
Port Configuration Command Set
Setting Speed and Duplex Mode
Section
4.1.2.
4-13