Table of Contents
Advertisement
Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable single Spanning Tree hello mode on the device. Per-port hello
times can now be configured using the set spantree hellomode command as described in
Section
6.2.1.21:
Matrix>set spantree bridgehellomode disable
6.2.1.20 clear spantree bridgehellomode
Use this command to reset the Spanning Tree administrative hello mode to enabled.
clear spantree bridgehellomode
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the Spanning Tree bridge hello mode to enabled:
Matrix>clear spantree bridgehellomode
6.2.1.21 set spantree hello
Use this command to set the hello time for the bridge or for one or more ports. This is the time
interval (in seconds) the device will transmit BPDUs indicating it is active.
set spantree hello interval [port-string]
6-22
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Advertisement
Table of Contents
