Table of Contents
Advertisement
11.2.2.10disconnect
Use this command to close an active console port or Telnet session when operating in switch mode.
disconnect {ip_address | console}
Syntax Description
ip_address
console
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to close a Telnet session to host 10.1.10.10:
Matrix>disconnect 10.1.10.10
This example shows how to close the current console session:
Matrix>disconnect console
11.2.3 Managing Switch Network Addresses
Purpose
To display, add or delete switch ARP table entries, to display or set the status of RAD (Runtime
Address Discovery) protocol, to display or delete MAC address information, to configure MAC
address aging time, to configure DNS, and to execute PING and traceroute.
Specifies the IP address of the Telnet session to be
disconnected. This address is displayed in the output
shown in
Section
Closes an active console port.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Logging and Network Management Command Set
Managing Switch Network Addresses
11.2.2.9.
11-33
Advertisement
Table of Contents
