Table of Contents
Advertisement
Port Configuration Command Set
Setting Speed and Duplex Mode
Example
This example shows how to set Fast Ethernet expansion module 3, port 9, to a port speed of 10
Mbps:
Matrix>set port speed fe.3.9 10
4.3.3.3
show port duplex
Use this command to display the configured port duplex setting (half or full) for one or more ports
used when the port's auto-negotiation state is disabled. Note that the configured duplex setting may
be different from the current assigned setting, if auto-negotiation is enabled.
show port duplex [port-string]
Syntax Description
port-string
Command Defaults
If a port string is not entered, configured port duplex settings for all ports are
displayed.
Command Type
Switch command.
Command Mode
Read-Write.
4-16
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
(Optional) Specifies the port(s) for which duplex
setting will be displayed. For a detailed description of
possible port-string values, refer to
Section
4.1.2.
Advertisement
Table of Contents
