Table of Contents
Advertisement
Process Overview: Routing Protocol Configuration
Configuring VRRP
Example
This example shows how to disable preempt mode on VLAN 1, VRID 1:
Matrix>Router(config)#router vrrp
Matrix>Router(config-router)#no preempt vlan 1 1
13.1.5.8 enable
Use this command to enable VRRP on an interface.
enable vlan vlan_id vrid
NOTE: Before enabling VRRP, you must set the other options described in this section.
Once enabled, you cannot make any configuration changes to VRRP without first
disabling it using the no enable vlan command.
Syntax Description
vlan vlan_id
vrid
Command Syntax of the "no" Form
The "no" form of this command disables VRRP on an interface:
no enable vlan vlan_id vrid
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router(config-router)#
Command Defaults
None.
13-84
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies the number of the VLAN on which to enable
VRRP. This VLAN must be configured for IP routing as
described in
Section
Specifies the Virtual Router ID (VRID) associated with the
vlan_id. Valid values are from 1 to 255.
3.3.2.
Advertisement
Table of Contents
