Show Spantree Autoedge - Enterasys 1G58x-09 Configuration Manual

Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the bridge forward delay to 15 seconds:
Matrix>clear spantree fwddelay

6.2.1.27 show spantree autoedge

Use this command to display the status of automatic edge port detection.
show spantree autoedge
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of the automatic edge port detection function:
Matrix>show spantree autoedge
autoEdge is currently enabled.
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Spanning Tree Configuration Command Set
6-27