Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the default path cost values to 802.1D:
Matrix>set spantree legacypathcost enable
6.2.1.32 clear spantree legacypathcost
Use this command to reset path cost to 802.1D values.
clear spantree legacypathcost
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset legacy path cost:
Matrix>clear spantree legacypathcost
6.2.1.33 show spantree tctrapsuppress
Use this command to display the status of topology change trap suppression on Rapid Spanning
Tree edge ports.
show spantree tctrapsuppress
6-30
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide