Table of Contents
Advertisement
Example
This example shows how to display SNMP notify filter information. In this case, the notify profile
"pilot1" in subtree 1.3.6 will receive SNMP notification messages:
Matrix>show snmp notifyfilter
--- SNMP notifyFilter information ---
Profile
Subtree
Filter type
Storage type
Row status
5.2.7.10 set snmp notifyfilter
Use this command to create an SNMP notify filter configuration. This identifies which management
targets should and should not receive notification messages, which is useful for fine-tuning the
amount of SNMP traffic generated.
By default, all management targets are excluded from receiving notification messages; therefore,
you must create an SNMP notify filter for the management targets that should receive notification
messages. If you create an SNMP notify filter to include all OIDs, you can then create SNMP notify
filters to exclude specific OIDs. As an alternative, you can create SNMP notify filters to include
specific OIDs; in which case, the OIDs that you do not specify will be excluded automatically.
set snmp notifyfilter profile subtree oid [mask mask] [included | excluded]
[volatile | nonvolatile]
Syntax Description
profile
subtree oid
mask mask
included | excluded (Optional) Specifies that subtree is included or excluded.
volatile |
nonvolatile
= pilot1
= 1.3.6
= included
= nonVolatile
= active
Specifies an SNMP filter notify name.
Specifies a MIB subtree target for the filter.
(Optional) Applies a subtree mask.
(Optional) Specifies a storage type.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
SNMP Command Set
Configuring SNMP Notification Parameters
5-57
Advertisement
Table of Contents
