Table of Contents
Advertisement
SNMP Command Set
Configuring SNMP Notification Parameters
Command Mode
Read-Write.
Example
This example shows how to enable the new MAC address trap function on port ge.0.3:
Matrix>set newaddrtrap ge.0.3 enable
5.2.7.6
show snmp notify
Use this command to display the SNMP notify configuration, which determines which
management targets will receive SNMP notifications.
show snmp notify [notify]
Syntax Description
notify
Command Defaults
If a notify name is not specified, all entries will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
5-52
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
(Optional) Displays notify entries for a specific notify
name.
Advertisement
Table of Contents
