Table 13-1 RIP Configuration Task List and Commands (Continued)
To do this...
Configure RIP authentication.
Disable automatic route summarization
(necessary for enabling CIDR)
Disable triggered updates.
Disable or re-enable split horizon.
Control the processing of routing updates.
Enable redistribution from non-RIP
routes.
13.1.1.1 router rip
Use this command to enable or disable RIP configuration mode.
router rip
NOTE: You must execute the router rip command to enable the protocol before
completing many RIP-specific configuration tasks. For details on enabling configuration
modes, refer to
Use these commands...
key chain
key
key-string
accept-lifetime
send-lifetime
ip rip authentication keychain
ip rip authentication mode
no auto-summary
ip rip disable-triggered-updates
ip split-horizon
passive-interface
receive interface
distribute-list
redistribute
Table 3-10
in
Section
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Process Overview: Routing Protocol Configuration
(Section
13.1.1.9)
(Section
13.1.1.10)
(Section
13.1.1.11)
(Section
(Section
(Section
(Section
(Section
(Section
(Section
(Section
13.1.1.22)
3.3.3.
Configuring RIP
13.1.1.12)
13.1.1.13)
(Section
13.1.1.14)
(Section
13.1.1.15)
13.1.1.16)
(Section
13.1.1.17)
13.1.1.18)
13.1.1.19)
13.1.1.20)
13.1.1.21)
13-3