Table of Contents
Advertisement
Example
This example shows how to use traceroute to display a round trip path to host 192.167.252.17. In
this case, hop 1 is the Matrix E1 switch, hop 2 is 14.1.0.45, and hop 3 is back to the host IP address.
Round trip times for each of the three UDP probes are displayed next to each hop
Matrix>traceroute 192.167.252.17
traceroute to 192.167.252.17 (192.167.252.17), 30 hops max, 40 byte packets
1
matrix.enterasys.com (192.167.201.40)
2
14.1.0.45 (14.1.0.45)
3
192.167.252.17 (192.167.252.17)
11.2.3.24set mac multicast
Use this command to configure a "scoping" egress VLAN that can be assigned to an ingress
multicast MAC – VLAN pair. A maximum of 32 ingress MAC address – VLAN pairs may be
configured.
set mac multicast mac_address ingress_vlanid egress_vlanid
Syntax Description
mac_address
ingress_vlanid
egress_vlanid
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
40.000 ms
10.000 ms
50.000 ms
Specifies the ingress MAC address of the MAC address –
VLAN pair to scope to the specified egress VLAN.
Specifies the number identifying the ingress VLAN of the
MAC address – VLAN pair to scope to the specified egress
VLAN.
Specifies the number identifying the egress VLAN.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Logging and Network Management Command Set
Managing Switch Network Addresses
20.000 ms
20.000 ms
20.000 ms
0.000 ms
:
20.000 ms
20.000 ms
11-57
Advertisement
Table of Contents
