Table of Contents
Advertisement
Logging and Network Management Command Set
Managing Switch Network Addresses
11.2.3.5 set rad
Use this command to enable or disable RAD (Runtime Address Discovery) protocol. The Matrix
E1 uses BOOTP/DHCP to obtain an IP address if one hasn't been configured. RAD can also be used
to retrieve a text configuration file from the network.
NOTE: In order for RAD to retrieve a text configuration file, the file must be specified in
the BootP tab.
set rad {enable | disable}
Syntax Description
enable | disable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable RAD:
Matrix>set rad disable
11.2.3.6 show mac
Use this command to display MAC addresses information in the switch's routing table.
show mac [address mac address] [fid vlan_id] [port port-string] [type {learned
| self | mgmt}]
11-38
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Enables or disables RAD.
Advertisement
Table of Contents
