IGMP Configuration Command Set
Enabling / Disabling IGMP
10.2 IGMP CONFIGURATION COMMAND SET
10.2.1 Enabling / Disabling IGMP
Purpose
To display IGMP status and to enable or disable IGMP snooping on the device.
Commands
The commands needed to display, enable and disable IGMP are listed below and described in the
associated sections as shown.
•
show igmp
(Section
•
set igmp
(Section
10.2.1.1 show igmp
Use this command to display IGMP information.
show igmp [groups | query-interval | response-time]
Syntax Description
groups
query-interval
response-time
Command Defaults
If no parameters are specified, IGMP status (enabled or disabled) will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
10-2
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
10.2.1.1)
10.2.1.2)
(Optional) Displays a list of IGMP streams and client
connection ports.
(Optional) Displays (in seconds) the frequency of
host-query frame transmissions.
(Optional) Displays (in tenths of a second) the maximum
query response time.