Table of Contents
Advertisement
9.3.5.1
set priority classification ingress
Use this command to add ports to a priority classification rule. These ports will then be active for
this rule.
set priority classification ingress priority_value port-string data_meaning
data_value [data_mask]
Syntax Description
priority_value
port-string
data_meaning
data _value
data_mask
Command Defaults
Data masks are required only for classification types requiring a second
data_value. For details, refer to
Command Type
Switch command.
Command Mode
Read-Write.
Port Priority and Classification Configuration Commands
Specifies the number of the port priority (0 through 7)
being associated with the priority ingress classification
list.
Specifies the port(s) being added to the port priority
ingress classification list. For a detailed description of
possible port-string values, refer to
Specifies the data_meaning for the parameter used to
classify frames. Refer to
data_meanings and associated protocol types and
classifications.
Specifies the code of a predefined classifier. The range of
codes is dependent on the data_meaning. Refer to
Table 9-1
for the limitations.
(Not required for most data values) Specifies a value
dependent on the data_value entered. For details, refer to
Table
9-1.
Table
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Classification Precedence Rules
Table 9-1
9-1.
Section
4.1.2.
for the list of the
9-31
Advertisement
Table of Contents
