Set Garp Timer - Enterasys 1G58x-09 Configuration Manual

VLAN Configuration Command Set
Enabling/Disabling GVRP (GARP VLAN Registration Protocol)
7.3.8.4

set garp timer

Use this command to adjust the values of the join, leave, and leaveall timers.
set garp timer {[join timer_value] [leave timer_value] [leaveall timer_value]}
port-string
NOTE: The setting of these timers is critical and should only be changed by personnel
familiar with the 802.1Q standards documentation, which is not supplied with this
device.
Syntax Description
join timer_value
leave timer_value Sets the GARP leave timer in centiseconds (Refer to
leaveall
timer_value
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the GARP join timer value to 100 centiseconds for all the ports on
all the VLANs:
Matrix>set garp timer join 100
7-48 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Sets the GARP join timer in centiseconds (Refer to 802.1Q
standard.)
802.1Q standard.)
Sets the GARP leaveall timer in centiseconds (Refer to
802.1Q standard.)
Specifies the port(s) on which to configure GARP timer
settings. For a detailed description of possible port-string
values, refer to Section 4.1.2.