Table of Contents
Advertisement
11.2.3.23traceroute
Use this command to display a hop-by-hop path through an IP network from the device to a
specific destination host when operating in switch mode. Three UDP or ICMP probes will be
transmitted for each hop between the source and the traceroute destination.
traceroute [-w waittime] [-f first-ttl] [-m max-ttl] [-p port] [-q nqueries] [-s
src-addr] [-r] [-d] [-t tos] [-F] [-g gateway] [-I] [-n] [-v] [-x] host [packetlen]
Syntax Description
-w waittime
-f first-ttl
-m max-ttl
-p port
-q nqueries
-s src-addr
-r
-d
-t tos
-F
-g gateway
-I
-n
-v
(Optional) Specifies time in seconds to wait for a
response to a probe.
(Optional) Specifies the time to live (TTL) of the first
outgoing probe packet.
(Optional) Specifies the maximum time to live (TTL)
used in outgoing probe packets.
(Optional) Specifies the base UDP port number used in
probes.
(Optional) Specifies the number of probe inquiries.
(Optional?) Specifies the source IP address to use in
outgoing probe packets.
(Optional) Bypasses the normal host routing tables.
(Optional) Sets the debug socket option.
(Optional) Sets the type of service (TOS) to be used in
probe packets.
(Optional) Sets the 'don't fragment' bit.
(Optional) Specifies a loose source gateway (up to 8 can
be specified), or specifies a specific gateway, such as
gw1.
(Optional) Specifies the use of ICMP echo requests rather
than UDP datagrams.
(Optional) Displays hop addresses numerically.
(Supported in a future release.)
(Optional) Displays verbose output, including the size
and destination of each response.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Logging and Network Management Command Set
Managing Switch Network Addresses
11-55
Advertisement
Table of Contents
