SNMP Command Set
Configuring SNMP Target Addresses
Example
This example shows how to set an SNMP target address of "1" associated with a parameter called
v1ExampleParams on IP address 127.0.0.1 and UDP port 160:
Matrix>set snmp targetaddr 1 param v1ExampleParams ipaddress 127.0.0.1 udp 160
5.2.6.3
clear snmp targetaddr
Use this command to delete an SNMP target address entry.
clear snmp targetaddr targetAddr
Syntax Description
targetAddr
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear SNMP target address entry "1":
Matrix>clear snmp targetaddr 1
5-46
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies the target address entry to delete.