Process Overview: Routing Protocol Configuration
Configuring OSPF
Table 13-4 show ip ospf interface Output Details (Continued)
Output
Backup Designated
Router id
Timer intervals
configured
Neighbor Count
Adjacent neighbor
count
Adjacent with
neighbor
13.1.2.27show ip ospf neighbor
Use this command to display the state of communication between an OSPF router and its neighbor
routers.
show ip ospf neighbor [detail] [ip_address] [vlan vlan_id]
13-58
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
What It Displays...
IP address of the backup designated router on this interface,
if one exists.
OSPF timer intervals. These are either default, or configured
with the ip ospf retransmit-interval
ip ospf hello-interval
dead interval
(Section
timer represents the amount of time a router waits before
initiating a designated router/backup designated router
election. The wait timer changes when the dead interval
changes. The retransmit timer represents the amount of time
between successive transmissions of LSAs (Link State
Advertisements) until acknowledgement is received.
Number of neighbors over this interface.
Number of adjacent (FULL state) neighbors over this
interface.
IP address of the adjacent neighbor.
(Section
(Section
13.1.2.9), and the ip ospf
13.1.2.10) commands. The wait
13.1.2.7), the