Set Trap; Clear Trap - Enterasys 1G58x-09 Configuration Manual

5.2.7.2

set trap

Use this command to assign an SNMP trap to an IP address. Since the device is an SNMP compliant
device, it can send messages to multiple network management stations to alert users of status
changes. For details on the types of traps this device supports, refer to the appropriate Matrix E1
Release Notes.
set trap ip_ address community_name {enable | disable}
Syntax Description
ip_address
community_name
enable | disable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable a trap on IP address 172.29.65.123 in the "blue" community:
Matrix>set trap 172.29.65.123 blue enable
5.2.7.3

clear trap

Use this command to clear an SNMP trap assigned to an IP address.
clear trap ip_address
Syntax Description
ip_address
Command Defaults
None.
Specifies the IP address of the management station where
traps will be set.
Specifies the community name of the trap to be set.
Enables or disables the trap.
Specifies the IP address of the trap to be cleared.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
SNMP Command Set
Configuring SNMP Notification Parameters
5-49