Syntax Description
sid
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the VLAN(s) mapped to Spanning Tree 1. In this case, VLANs
2, 16 and 42 are mapped to SID 1. For this information to display, the SID instance must be created
using the set spantree msti command as described in
to SID 1 using the set spantree mstmap command as described in
Matrix>show spantree vlanlist 1
The following VLANs are assigned to SID 1: 2 16 42
6.2.1.13 show spantree mstcfgid
Use this command to display the MST configuration identifier elements, including format selector,
configuration name, revision level, and configuration digest.
show spantree mstcfgid
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Reviewing and Setting Spanning Tree Bridge Parameters
Specifies a Multiple Spanning Tree ID. Valid values are 1 -
4094, and must correspond to a SID created using the set
spantree msti command as described in
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Spanning Tree Configuration Command Set
Section
6.2.1.7, and the FIDs must be mapped
Section
Section
6.2.1.7.
6.2.1.10:
6-17