Table of Contents
Advertisement
Example
This example shows how to display Denial of Service security status and counters. For details on
how to set these parameters, refer to
Matrix>Router(config)#show HostDos
LANDd Attack (Destination IP = Source IP)
Spoofed Address Check
IP packet with multicast/broadcast source address
Fragmented ICMP traffic
Large ICMP packet
Ping-of-Death attack
Port Scanning
14.3.8.2 HostDos
Use this command to enable or disable Denial of Service security features.
HostDos {land | fragmicmp | largeicmp size | checkspoof | portscan}
ROUTER: This command can be executed when the device is in router mode only.
For details on how to enable router configuration modes, refer to
Section 14.3.8.2
Disabled
Disabled
Always enabled
0 attacks
Disabled
Disabled
Always enabled
0 attacks
Disabled
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Security Configuration Command Set
Configuring Denial of Service Prevention
:
Section
3.3.3.
14-99
Advertisement
Table of Contents
