Set Snmp Authentication Trap - Enterasys 1G58x-09 Configuration Manual

SNMP Command Set
Configuring SNMP Access Rights
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of the SNMP authentication trap function:
Matrix>show snmp authenticatontrap
authentication traps enabled
5.2.3.5

set snmp authentication trap

Use this command to enable or disable the SNMP authentication trap function.
set snmp authenticationtrap {enable | disable}
Syntax Description
enable | disable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the SNMP authentication trap function:
Matrix>set snmp authenticatontrap enable
5-32 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Enables or disables the sending of SNMP authentication
failure traps.