Table of Contents
Advertisement
Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
Syntax Description
detection-id
h323 | siemens
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the phone detection type to H.323 for CEP group 1
Matrix>set cep detection 1 type h323
11.2.6.7 set cep detection address
Use this command to set an H.323 or Siemens phone detection group's IP address or mask. By
default, H.323 will use 224.0.1.41 as its IP address and Siemens will have no IP address configured.
set cep detection detection-id {[address {ipv4 ip-address | unknown}] [mask
{ipv4 mask | unknown}]}
NOTE: This command applies only to Siemens and H.323 phone detection. Cisco
detection uses CiscoDP as its discovery method.
11-80
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies a CEP discovery group ID. This group must be
created and enabled using the set cep detection command
as described in
Section
2147483647.
Specifies the phone type to detect as H.323 or Siemens.
11.2.6.5. Valid values are 1 -
:
Advertisement
Table of Contents
