Table of Contents
Advertisement
Connecting to a Console Port for Local Management
Connecting to a Modem
Parameter
Mode
Transmit
Bits Parity
Stop Bit
5. When these parameters are set, the Matrix E1 startup screen will display.
Figure 2-2 Connecting a VT Series Terminal
À
1 VT Series Terminal
2 RJ45-to-DB25 VT Adapter
2.1.4
Connecting to a Modem
To connect a modem to an Enterasys Networks device modem port
with RJ45 connectors and an optional RJ45-to-DB25 male adapter (PN 9372112), and proceed as
follows:
1. Connect the RJ45 connector at one end of the cable to the modem port on the Enterasys
Networks device.
2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB25 male adapter. Refer
to
Section 2.1.5
2-4
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Á
for adapter wiring and signal assignments.
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Â
3 UTP Cable with RJ45 Connectors
4 RJ45 Console Port
Ã
(Figure
2-3), use a UTP cable
Advertisement
Table of Contents
